An alumina sputtering target order should identify the source material, the ceramic specification, and the assembly your RF cathode accepts. Start with the tool owner’s approved configuration. Then ask the supplier to quote a target that meets those requirements and to identify the measurements it can document on the delivered lot.
Specify the source as aluminum oxide
Alumina is aluminum oxide (Al₂O₃), an electrically insulating ceramic used to deposit dielectric films. An RF magnetron can be configured for an insulating target because alternating excitation helps manage charge at the target surface. A reactive process can also produce aluminum oxide from a metallic aluminum target in an oxygen-containing plasma. These routes use different source materials and require separate tool approval and process qualification. In the RFQ, write Al₂O₃ ceramic sputtering target if your process calls for the oxide source. Kurt J. Lesker alumina target specifications · University of Illinois study of reactive sputtering from aluminum
Request purity and density separately
Purity describes the material’s chemical composition under a stated reporting basis. Ask which impurities the supplier measures and whether the certificate of analysis covers the finished target, its production lot, or the starting powder. Include individual impurity limits if your film or process has a known sensitivity.
Bulk density describes the mass per unit volume of the ceramic target, including the volume occupied by pores. If you specify relative density, give it as a percentage of an agreed theoretical reference. Ask for the measured bulk density, the reference density, and the measurement method. For a specification involving porosity or a particular alumina phase, list that requirement separately. ISO 18754 on density and porosity measurements for fine ceramics
Confirm the cathode and backing configuration
Harvard’s Center for Nanoscale Systems lists Al₂O₃ among the available targets for its SP-2 sputtering system. The system uses 2-inch targets and includes RF guns for nonconductive materials. Use your own tool’s drawing, part number, or approved replacement specification to confirm diameter, thickness, and mounting. Ask the facility whether it accepts a bare ceramic or requires a bonded assembly. Harvard CNS SP-2 equipment listing
For a bonded assembly, specify the ceramic thickness, backing-plate material and dimensions, and maximum total assembled thickness. Include any bond or inspection requirements already qualified by the lab. If the backing plate will be reused, provide its drawing and ask the supplier to assess it before quoting. Basis guide to target and backing-plate dimensions
Send a quote request the supplier can check
- Material — Al₂O₃, required purity and reporting basis, individual impurity limits, and any phase requirement.
- Ceramic measurements — Required bulk or relative density, reference basis, and lot documentation.
- Fit — Cathode model, target drawing or part number, ceramic diameter and thickness, and any tolerances.
- Assembly — Bare or bonded, backing-plate details, total thickness, quantity, and required delivery date.
For a repeat order, reference the accepted drawing and certificate of analysis in your quote request and identify any changes. To share files, email them to sales@basismaterials.com. Basis Materials can review the geometry and documentation with your request. Aluminum oxide sputtering target · Request a quote