Skip to content

Titanium Sputtering Targets: How to Specify a Replacement

Machined titanium sputtering target disc beside a target holder on a laboratory bench

When you reorder a titanium sputtering target, start with the part that has already run on your tool. The previous part number, cathode model, and target drawing give the supplier more to work with than a request for a “2-inch titanium target.” They also make it easier for a buyer to compare quotes for the same material and configuration.

Carry over the qualified titanium grade

Write elemental titanium (Ti) on the request and copy the grade or minimum purity from the approved specification. Titanium dioxide (TiO₂) and titanium-tungsten (TiW) are separate target materials. Cornell NanoScale Facility, for example, lists Ti and TiW separately among the 3-inch targets available for one AJA system. That list identifies what the facility offers for that tool. Confirm the exact part and configuration with your own tool owner. Cornell NanoScale Facility AJA sputtering system

If your process specifies a purity basis or limits for particular impurities, include those requirements as well. Ask whether the available certificate of analysis describes the finished target, its production lot, or the starting material. For an exact reorder, share the old certificate and identify which limits and documents the replacement needs to match. Basis guide to metal purity and COAs

Match the mounting features as well as the diameter

Give the cathode manufacturer, model, and existing target or assembly part number. Include the nominal diameter, thickness, tolerances, and drawing revision. Check the drawing for a keeper, threaded hole, or other mounting feature. If the old disc is worn, use the drawing or purchase record for the original thickness. Treat any dimensions measured from the worn part as observations for the supplier to review.

Here is a catalog example. Kurt J. Lesker lists two 99.995% titanium targets with the same nominal dimensions of 2 inches in diameter by 0.250 inch thick. Part EJTTIXX452A4 is listed for most standard guns. Part EJTTIXX452TK4 includes a keeper for a specific TORUS Mag Keeper cathode. The drawing and mounting details distinguish the configurations when the nominal dimensions and purity match. Kurt J. Lesker titanium target catalog

Tell the supplier what assembly to quote

For a bare replacement, specify the titanium disc and any mounting features it needs. For a bonded replacement, give the target thickness and finished assembly thickness separately. Include the backing plate material and dimensions, the approved bond method if specified, and whether you want a new plate or plan to supply an existing one for review. Ask the supplier to identify any proposed departure from the drawing before you place the order.

Send the previous part number or drawing, qualified grade, bare or bonded configuration, quantity, and required delivery date in one request. If you need a replacement for more than one cathode, list each configuration separately so the quote can show which part fits each tool. Titanium sputtering target · Request a materials quote